Manual Bypass Tray Adjustment - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 1.0 Jun. 2008
5.2

Manual Bypass Tray Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
Upon setup of the Manual bypass tray unit.
Use when the manual bypass paper size unit of the manual bypass guide has been
changed.
Use when a false paper size is displayed when the manual bypass is used.
1. Call the Service Mode to the screen.
See P.146 of the main body service manual.
2. Touch [Machine Adjustment] → [Manual Bypass Tray Adjustment].
3. Touch [Max. Width].
[1]
4. Place the adjustment sheet (width:
5. Press the Start key.
A0EPF3C503DA
6. Check that "OK" appears beside
NOTE
• Make the adjustment again if the
results are "NG".
A0EPF3E515DA
5. Machine Adjustment
297 mm) [1] on the manual bypass
tray as illustrated.
[Max. Width].
17