Centering - Konica Minolta bizhub C200 Service Manual

5. Machine Adjustment
5.1.2

Centering

NOTE
• Make this adjustment after any of the following procedures has been performed.
When the PH unit has been replaced.
When the image on the print is offset in the main scan direction.
1. Call the Service Mode to the screen.
See P.146 of the main body service manual.
2. Touch [Machine Adjustment] → [Printer Area] → [Centering].
8. Produce another test print and check to see if width A falls within the specified range.
NOTE
• If the use of the [
the specified range, perform the following steps.
14
A0EPF3E517DA
A
4348fs3509c0
] or [ ] key does not allow the measurement to fall within
Field Service Ver. 1.0 Jun. 2008
3. Touch [Bypass Tray].
4. Press the Start key to let the
machine produce a test print.
5. Touch [OK].
6. Measure the width of printed refer-
ence line A.
Specification: 3.0 mm
7. If the measured width A falls outside
the specified range, enter the correc-
tion value using the [
key.
±
1.0 mm
] or [ ]