Konica Minolta bizhub C200 Service Manual page 655

5. Mechanical adjustment
[1]
[1]
12. Perform another test print and check the reference deviation.
13. Repeat the adjustment until the reference line falls within the specified range.
14. Tighten the adjustment screw.
15. Touch [OK].
16. Touch [OK] on the Service Mode screen.
17. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
26
[2]
4067F3C529DB
[2]
4067F3C530DA
Field Service Ver. 1.0 Jun. 2008
9. Slide out the drawer [1] and unload
paper from it.
10. Loosen two screws [2] at the center
of the paper lifting plate.
11. Watching the graduations [1] pro-
vided in the drawer, move the edge
guide [2] in the rear.
• If width A is greater than the specified
value, move the edge guide toward the
front.
• If width A is smaller than the specified
value, move the edge guide toward the
rear.