Feed - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 1.0 Jun. 2008
11. Touch [OK].
12. Press the Reset key.
13. Repeat steps 3 to 12 until the reference line lengths comply with the specifications.
14. Touch [OK] on the Service Mode screen.
15. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
5.2.2

Feed

Functions • To adjust the scan start positions in the main and sub scan directions of the ADF.
Use • Use upon setting up the ADF.
Adjustment • Width A (Leading edge misalignment): 0 ± 2.0 mm
specification • Width B (Lateral edge misalignment): 0 ± 2.0 mm
[Leading Edge]: -4.0 to +4.0
[Centering]: -72 to +72 (x 0.04 mm)
Adjustment [Leading (2nd)]: -5.0 to +5.0
range [Centering (2nd)]: -72 to +72 (x 0.04 mm)
[Leading (3rd)]: -6.0 to +6.0
[Centering (3rd)]: -72 to +72 (x 0.04 mm)
2. Call the Service Mode to the screen.
See P.146 of the main body service manual.
3. Touch [Machine Adjustment] → [Scan Area] → [Test Copy].
A0EYF3E510DA
[1]
A0EYF3C500DA
9. Touch [Cross Direction Adjustment]
or [Feed Direction Adjustment].
• Cross Direction Adjustment: A (Main
scan direction)
• Feed Direction Adjustment: B (Sub
scan direction)
10. Press the Clear key, and then enter
the numeric value from the 10-Key
Pad.
• If the line is longer than the specifica-
tions, adjust toward the reduction side.
• If the line is shorter than the specifica-
tions, adjust toward the enlargement
side.
1. Load the test chart [1] in the ADF.
5. Service Mode
35