8. Utility Mode
8.4
User Management
8.4.1
Confirmation Beep
Functions
• To set the sound when pressing the key on the control panel.
Use
• To change the volume of the key sound or to make no sound.
Setting/
• The default setting is 3.
Procedure
8.4.2
Alarm Volume
Functions
• To set the volume of the sound when alarm occurs or when the key operation is pro-
hibited.
Use
• To change the volume of the alarm or to make no sound.
Setting/
• The default setting is 3.
Procedure
8.4.3
Line Monitor Sound
See P.15 of the FK-507 service manual.
8.4.4
Job Complete Beep
Functions
• To set the volume of the beep when the job is complete.
Use
• To change the volume of the beep for complete or to make no sound.
Setting/
• The default setting is 3.
Procedure
8.4.5
Panel Cleaning
Functions
• To temporarily invalid the key operation on the panel when cleaning the control panel.
Enlarge Display key will stay valid.
Use
• To clean the control panel.
Setting/
• Pressing [Reset] key cancels the panel cleaning screen.
Procedure
8.4.6
Dehumidify
• It is not displayed when bit1 for the mode 478 is set to "0" by the following setting:
[Service Mode] → [System] → [Software Switch Setting].
Functions
• To turn on the scanner exposure lamp for the set period of time (five minutes) to
dehumidify the scanner.
Use
• To keep the image quality even when the scanner builds up condensation due to
rapid temperature change or high humidity.
Setting/
• Pressing [Dehumidify] button turns on the scanner exposure lamp to start dehumidi-
Procedure
fying.
124
Field Service Ver. 1.0 Jun. 2008
0 to 5
0 to 5
0 to 5