Regist Loop; Erasure Width - Konica Minolta bizhub C200 Service Manual

Field Service Ver. 1.0 Jun. 2008
5.2.3

Regist Loop

Functions • To adjust the length of the loop to be formed in paper before the registration rollers.
Use • When an original misfeed or skew occurs.
Adjustment
• The loop value increases by the entered + value and decreases by the entered - value.
instructions
Adjustment • [1-Sided]: -5 to +5 mm
range • [2-Sided]: -5 to +5 mm
1. Call the Service Mode to the screen.
2. Touch [Scan Area].
3. Touch [ADF Adjustment].
4. Touch [Regist Loop].
5. Select either [1-Side] or [2-Sided] for the adjustment.
Setting/ 6. Press the clear key and change the setting value using the 10-key pad. (Press the [+/-]
procedure key to change the +/- code.)
7. Touch [OK].
8. Press the Reset key.
9. Touch [OK] on the Service Mode screen.
10.Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
5.2.4

Erasure Width

Functions • To set the erase width of the ADF.
• Use when changing the width of the area not to be printed on the leading and side
Use
edges of the image.
Adjustment
• 0 to 3 mm
range
1. Call the Service Mode to the screen.
2. Touch [Scan Area].
3. Touch [ADF Adjustment].
4. Touch [Erasure Width].
Setting/
5. Enter the numeric value from the 10-key pad and touch [OK].
procedure
6. Press the Reset key.
7. Touch [OK] on the Service Mode screen.
8. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
5. Service Mode
37