Connect To The Customer Data Network - Oracle FS1-2 Installation Manual

Any changes that you make are mirrored to the partner Controller, and the
system restarts.
Note: During startup, if the SFP detected does not match the port
provisioning, the system generates an "Incorrect SFP" event.
Related Links
Cabling Workflow
Connections to the Customer Data Network

Connect to the Customer Data Network

Connect to the Customer Data Network
SAN data paths require FC and iSCSI connections. Single-mode and multi-mode
optical fiber connections are supported on PCIe cards.
Prerequisites:
Note: The iSCSI SFPs are Gigabit Ethernet type, either 1 GbE or 10 GbE.
Note: The type of connection (Ethernet, FC, or iSCSI) was defined when the
Oracle FS System was ordered.
CAUTION: Use only the Oracle-supplied SFP modules for the external cabling.
The following figure shows the SAN HBA connections from the Controllers to
the customer data network.
The Fiber Channel (FC) data paths require 8 GbE or 16 GbE
•
optical FC connections.
The iSCSI connections require 10 GbE copper or optical
•
connections.
Connect to the Customer Data Network
89