Configure The Management Ip Addresses - Oracle FS1-2 Installation Manual

Configure the Management IP Addresses

Prior to connecting the Oracle FS System to the customer management network,
configure the settings for the Pilot management interface using the default IP
addresses on the Pilots.
Prerequisites:
1 From the laptop that is connected to the NET 3 port on Pilot 1, log into the
GUI using the administrator account.
The default password is
Use the default IP address of the Pilot (10.0.0.2) in the Oracle FS Name
field to connect to the Oracle FS System.
When you first log in to the GUI, you might receive a notice that the
administrator password has expired. Enter a new password and set a
password expiration that allows sufficient time to complete the installation
and the configuration of the system, such as 10 days.
Important: When you complete the installation and configuration, give the
new password to the person who is responsible for managing the system.
2 Navigate to Global Settings > Networking.
3 Select Actions > Modify.
4 Update the default IP addresses, netmask, and the gateway to match the
customer's network environment.
5 If the customer management network requires auto-negotiation to be
disabled, make sure that the interface speed and duplex setting of the Pilot
are set exactly the same as the settings on the switches that connect the
system to the customer management network.
Important: Auto-negotiation is strongly recommended. If the customer's
Ethernet switch supports 1 GbE or 10 GbE, do not disable auto-negotiation.
Disabling auto-negotiation should be avoided.
6 Verify that you entered the correct settings for the IP address, netmask, and
gateway.
Configure and Connect to the Customer Management Network
The customer-supplied Ethernet cables are connected to
•
the NET 3 ports on the Pilots.
A laptop is connected to the NET 3 port on Pilot 1 and you
•
can successfully ping 10.0.0.2.
The customer-supplied Ethernet cables are not connected
•
to the customer management network.
The system is powered on and has a status of Normal. Do
•
not continue if the system status is not Normal.
Configuration updates fail if the system does not have a
status of Normal.
The software for Oracle FS System Manager (GUI) is
•
installed on a laptop, and the laptop is connected to the
NET 3 port on Pilot 1.
pillar
.
68