Oracle FS1-2 Installation Manual page 29

Table 14: Site preparation checklist (continued)
Check Site preparation or pre-installation planning items
❑
Check the Oracle Technology Network (OTN) (http://www.oracle.com/
technetwork/documentation/oracle-unified-ss-193371.html) for all relevant
documentation:
For instructions on system unpacking, installation, and initial
•
configuration, refer to this guide.
For instructions on installing software updates, refer to the
•
Oracle FS1-2 Flash Storage System Release Notes and to the
Oracle Flash Storage System Administrator's Guide.
For instructions on configuring the system, refer to the Oracle
•
Flash Storage System Administrator's Guide.
For instruction on servicing the replaceable units within the
•
system, refer to the Oracle FS1-2 Flash Storage System Field
Service Guide.
Data path interface requirements
❑
Ensure that data path interfaces or connectors meet Oracle specifications
and speed requirements.
Network connectivity requirements
❑
Two 1 Gb or 10 Gb Ethernet network cables, one for each Pilot to enable
Pilot connectivity to the management network.
❑
Obtain three IP addresses for the Pilot management interfaces. The shared
IP address may be assigned using DHCP. The address for each Pilot may
not be assigned using DHCP. DNS hostnames for the Pilot management
interfaces are optional, but recommended. The standard Pilot
configuration or the Oracle FS System factory default IP addresses are as
follows:
Shared IP: 10.0.0.2
•
Pilot–1: 10.0.0.3
•
Pilot–2: 10.0.0.4
•
Gateway: 10.0.0.1
•
Netmask: 255.255.255.0
•
Note: If the installer gets three replacement IP addresses, then those
replacement IP addresses must be used instead of the factory default IP
addresses.
Global system parameters
Oracle FS Systems: Installation Overview
29