Table of Contents
Advertisement
CAUTION: Do not proceed to the next step until after you have verified the
new settings for the IP address, netmask, and gateway.
7
Click OK.
With the updated IP address, your laptop will lose connectivity to the
active Pilot.
8
To reconnect the laptop to the active Pilot, update the TCP/IP configuration
of the laptop to match the Pilot's newly configured IP address, netmask,
and gateway.
9
From the laptop, verify that you can log into the GUI using the updated IP
address.
Connect to the Customer Management Network
To enable the customer to manage the Oracle FS System, connect the Pilots to the
customer management network.
Prerequisites:
To ensure that Pilot 1 remains as the active Pilot, the laptop must be connected to
the NET 3 port on Pilot 1 until you are ready to connect the Pilots to the customer
management network. To avoid a fail over from Pilot 1, connect the Pilots to the
customer management network within five minutes of disconnecting the laptop
from Pilot 1.
If the laptop is disconnected from Pilot 1 and not connected to the customer
management network within five minutes, Pilot 1 will fail over to Pilot 2. Pilot 2
then becomes the active Pilot. Power cycle both of the Pilots to make Pilot 1
active again.
Note: If you power cycle the Pilots prior to connecting to the customer
management network, it might take up to 10 minutes for the Pilot IP addresses to
respond to the ping. It might take an additional five minutes for the IP address
for the customer management network to respond to the ping.
1
Disconnect the laptop from the NET 3 port on Pilot 1.
Configure and Connect to the Customer Management Network
The IP addresses of the Pilot management interface must
•
be configured before you connect the system to the
customer management network.
Ensure that the IP address of the customer management
•
network and the IP addresses of the Pilots respond to a
ping
The customer's firewalls allow the following TCP ports bi-
•
directional access between the management workstations
and the IP addresses configured for the Pilots:
TCP Port 80 for downloading the management
•
software
TCP Port 26012 for access to the GUI and FSCLI
•
69
Advertisement
Table of Contents
