Fit the spacer (S) of the tool no. 88713.2878 between the connecting rods and take up residual axial
clearance with the fork feeler gauge (T) of the tool no. 88713.2878 which is available in the following
thickness values:
- 0.1 mm - 0.2 mm - 0.3 mm.
Using a torque wrench as shown in the figure, tighten screws (3) to the values specified here below:
tighten to 35 Nm;
-
pause of 2 seconds and 360° loosening;
-
snug to 20 Nm;
-
snug to 35 Nm;
-
tighten with a rotation of 65°±1°;
-
torque check 70÷103 Nm.
-
Remove the feeler gauge and check that connecting rods/crankshaft end float is: 0.15÷0.35 mm.
1152
Ducati Manuals Resource