Copy Control - Fuji Xerox ApeosPort-II C4300 User Manual

Booklet Creation - Covers Tray
Set the default value for [Covers Tray] in the [Booklet Creation] screen.
Covers - Covers Tray
Set the default value for [Covers Tray] in the [Covers] screen.
Build Job - Separators Tray
Set the default value for [Separators] in the [Build Job - Separators Tray] screen.

Copy Control

These settings relate to copy operation control.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to Auto
Job Release (P.273).
Cancel Job
The stored data is discarded.
Run Job
The read-in data is treated as valid, and the part of the original read in is copied.
Maximum Stored Pages
Set the maximum number of stored pages of a copy original. You can set a number from 1 to
999 pages.
Auto Paper Off
Select the tray used when [Auto Paper] of [Paper Supply] in the [Copy] screen is cancelled
(the tray used when [Auto Paper] of [Paper Supply] is selected in the [Copy] screen, and
[Auto %] or [Independent X-Y %] is selected for [Reduce/Enlarge]).
Mixed Sized Originals - 2 Sided Copy
Specify paper to copy side 2 of the original if different size of originals for side 1 and side 2
are selected by automatic paper supply when the size of the side 1 differs from that of the
side 2 in 2-sided copy.
Important • When the side 1 and side 2 are different sizes and if the side 2 is copied on the sheet on
Copy to new sheet
Side 2 is copied on the front of a new sheet.
Copy to Side 2
Side 2 is copied on the opposite side of Side 1 without changing the paper size.
Fine-tune 100%
You can fine-tune the magnification when copying at 100% (actual size). The set value is
applied when [Reduce/Enlarge] or [Preset %] on the [Copy] screen is set to 100%.
Set the value in the X/Y direction within the range 98 to 102% in 0.1% increments.
which the side 1 has already been printed, an image may be missing.
Copy Mode Settings
10
297