Fuji Xerox ApeosPort-II C4300 User Manual page 597

The hard clip setting is inactive. The hard clip area is always the paper's hard clip area.
If the document size = paper size, it plots at the same scale (100%).
If the document size > paper size, it plots at a reduced scale.
If the document size < paper size, it plots at the same scale (100%).
A0
A1
A2
A3
A4
A5
If the origin position for the plotting position is Layout, the document is laid out and
drawn in the center. If the origin position is bottom left or center, the origin of the
document and the paper are aligned and drawn.
If the Document Size is Auto and the Scaling Mode is ACA
The hard clip setting is inactive. The hard clip area is always the advanced hard clip
area.
The scaling factor is determined according to the ACA and the paper size. The range
for the ACA for each paper size is as follows:
Paper
Size
A3
A4
A5
B4
B5
The maximum scaling factor is 210% of the advanced hard clip area for each paper size
and the minimum scaling factor is 22.5%.
7. Restrictions When Plotting under Auto Layout
If the Printer is Equipped with Hard Disk(s)
When Auto Layout is used, print data is stored on the hard disk.
If the Printer is Not Equipped with hard disk(s)
When Auto Layout is used, print data is stored in layout memory.
The default layout memory is set at 100kbyte. Consequently, when print data
exceeding 100kbyte is received, a printer error occurs.
If this happens, change the Auto Layout memory capacity on the operation panel.
A3 A4
35
50
71
100
100 100
100 100
0 Degrees
Min Value Max Value
P2x - P1x P2y - P1y P2x - P1x
7829 5485 73075
5485 3828 51200
3828 2648 35733
6762 4723 63120
4723 3297 44088
A5
25 100
35 25
50 35
71 50
71
100
Min Value
P2y - P1y P2x - P1x P2y - P1y
51200 5485
35733 3828
24720 2648
44088 4723
30773 3297
HP-GL2 Emulation
B4 B5
31 100
43 31
61 43
87 61
100 87
100 100
90 Degrees
Max Value
P2x - P1x P2y - P1y
7829 51200 73075
5485 35733 51200
3828 44088 35733
6762 44088 63120
4723 30773 44088
Unit: Plotter Unit
595
16