Fuji Xerox ApeosPort-II C4300 User Manual page 510

15 Problem Solving
Error Code
C P F S M O
034-506
034-507
034-508
034-509
034-510
034-511
15
034-512
034-515
034-519
034-520
034-521
034-522
034-523
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
508
Category
O [Cause]
[Remedy] Check if the destination machine has the remote copy
O [Cause]
[Remedy] Check the password and the phone number.
O [Cause]
[Remedy] Check the settings and the phone number, and send the
O [Cause] Unable to send with the Relay Broadcast feature.
[Remedy]Check if Relay Broadcast is correctly set for the
For information on Relay Broadcast, refer to "Relay Broadcast
(Transmitting Documents Through a Relay Station)" (P.152). For
information on Remote Relay Broadcast, refer to "Remote Relay Broadcast
(Performing Relay Broadcast to Remote Locations)" (P.156).
O [Cause]
[Remedy] Check the abbreviated number of the relay broadcast.
For information on Remote Relay Broadcast, refer to "Remote Relay
Broadcast (Performing Relay Broadcast to Remote Locations)" (P.156).
O [Cause]
[Remedy] Check the conditions of the destination machine.
O [Cause]
[Remedy] Wait until the waiting jobs decrease, or reduce the number
O [Cause]
[Remedy] Wait until the waiting jobs decrease, and try again.
O [Cause]
[Remedy] Turn off and on the machine. If the error persists, contact
O [Cause]
[Remedy] Wait until the job in communication is completed, and try
O [Cause]
[Remedy] Retry after waiting for a while.
Cause and Remedy
The destination machine does not have the remote copy
feature (for printing the multiple sets of a received
document).
feature.
The specified password is not identical with the ID number
of the destination machine.
The destination machine may be set not to send its ID
number. Check the setting of the destination machine.
This error code also appears when polling is rejected.
An error occurred during fax transmission.
fax again. If the machine conditions are not improved by
performing the relevant remedy, contact our Customer
Support Center.
abbreviated number.
If the registered number is incorrect, modify it. Check also
the abbreviated number registered in the relay station.
An infinite loop was detected on the remote relay
broadcast.
Check also the abbreviated number registered in the relay
station.
The destination machine has a problem.
The number of destinations specified for the broadcast
transmission exceeded the upper limit.
of destinations, and try again.
The number of waiting jobs exceeded the upper limit.
An error occurred while faxing.
our Customer Support Center.
There is no line available for the manual communication.
again.
Unable to accept jobs.