Notes And Restrictions When Connecting With Internet Service Provider - Fuji Xerox ApeosPort-II C4300 User Manual

16 Appendix
For information on restricting domains from which e-mail can be received, refer to "Domain Filter"
(P.301).
Notes on E-mail Receptions
E-mail of large size may not be printed due to insufficient memory. In such a case,
increase the memory size or ask the sender to lower the resolution.

Notes and Restrictions when Connecting with Internet Service Provider

This section describes notes and restrictions on features relating E-mail that accesses
with a Internet service provider (ISP).
The following shows the features relating E-mail.
Notes and Restrictions on accessing ISP
The following are the notes and restrictions on connecting the machine to ISP.
16
Feature Specifications
The following shows the features relating to E-mail.
604
Mail scanning
Mail Notice Service
iFax
E-mail Printing
Dial-up connection is not supported. Continuous connection is required.
Connect the machine under circumstances using IP masquerade. Assigning a global
IP address to the machine is not supported.
Make sure to assign an exclusive e-mail account to the machine for POP receiving.
Shearing an e-mail account with other users may cause troubles.
Make sure to set size limitation for sending e-mail. The applicable e-mail size may
vary depending on the ISP used, however, it is recommended you set a small value.
Continuous connection other than ADSL or cable connection is also supported;
however, it burdens the machine when image data is sent or received.
SMTP receiving is not supported. This machine supports only POP receiving.
When installing the machine in a circumstance using a mail transfer agent (MTA) in
a private segment, set the machine to fit the operation system.
When received via POP, the fax cannot be sent using the Fax Gateway feature. This
is because POP receiving does not forward an iFax document received by e-mail to
the fax machine.
For information about supported ISPs, contact our Customer Support Center.
Transmission specifications
Supported protocol
Port number
Authentication for transmission
SMTP authentication
POP before SMTP
Waiting time for POP authentication : cannot change
: SMTP
: 25 fixed (cannot change port numbers)
: supported
: Plain and APOP