Delete Form; Other Settings - Fuji Xerox ApeosPort-II C4300 User Manual

Carries out spooling. The receiving buffer for spooling uses the hard disk.
Note • This feature does not appear for some models. An optional package is necessary. For more
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer.
Specify a value within the range from 1,024 to 2,048 KB, in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port 9100 receiving buffer.
Specify a value within the range from 64 to 1,024 KB in 32 KB increments.

Delete Form

You can delete registered ESC/P forms.
1
Select [Delete Form].
2
Select the print mode to delete
forms.
3
Enter the form number with the
numeric keypad, and select
[Confirm].
4
Check the form name, and select [Delete Data].
ESC/P
Delete ESC/P emulation forms.
Form Number
When you select an item to be deleted, you can enter the form number. Specify a form
number from 1 to 64 (when a hard disk is installed, from 1 to 2,048).
Form Name
After you enter the form number and select [Confirm], the form name matching the entered
number appears.

Other Settings

You can make other settings relating to the paper used in the printer.
Print Area
Set whether to expand the print area.
For information about the printable area, refer to Printable Area (P.563).
Substitute Tray
When there is no tray containing the paper size selected by the automatic tray selection,
select whether or not to print replaced with paper loaded in another paper tray. In the event of
using substitute tray, set the size.
Display Message
Does not use a substitute tray, but displays a paper loading message.
Use Larger Size
Replaces with the next larger paper size than that selected, and prints at the same size.
information, contact our Customer Support Center.
Print Mode Settings
10
305