Fuji Xerox ApeosPort-II C4300 User Manual page 415

When the waste toner container becomes full, a message appears on the touch screen.
If you continue copying or printing without replacing the waste toner container, a
message appears and the machine stops after copying or printing about 900 pages.
When replacing the waste toner container, clean the laser scanner (D1, D2, D3, D4)
located at the rear of the container using the cleaning stick supplied with a new waste
toner container. This can prevent uneven copy/print density and coloring.
Important • When replacing the waste toner container, toner may spill on the floor. We recommend
laying paper on the floor beforehand.
• Used waste toner containers require special processing during disposal. Return all used
toner cartridges to our Customer Support Center.
• The use of waste toner containers not recommended by Xerox may impair quality and
performance. Use only waste toner containers recommended by Xerox for the machine.
• Replace the waste toner container while the machine is on.
Note • The number of pages is for when A4 ( ) paper is used.
• The number of copies that can be printed is only an estimate and varies depending on the
image type, paper size, paper type, and the machine usage environment.
1
Prepare a new waste toner
container.
Note • Take a new bottle, orange
plastic cap, and cleaning stick
out of the box.
2
Make sure that the machine is not
in operation, and open the front
cover.
3
Pull open the black cover on the
machine's front face (B) by holding
its left and right orange levers.
4
Hold the center part of the waste
toner container to pull the container
towards you until it stops.
Important • Place the removed waste
toner container on the open
black cover. Be careful not to
tilt the container to keep toner
from spilling.
Replacing Consumables
Plastic cap
Cleaning stick
Waste toner container
14
413