Fuji Xerox ApeosPort-II C4300 User Manual page 41

3
Select [System Settings].
4
Select [System Settings].
5
Select [Common Settings].
6
Select [Machine Clock/Timers].
7
Select [ ].
8
Select [Auto Power Saver], and select [Change Settings].
9
Using [ ] and [ ], configure a
power saver mode migration time
in 1 minute increments.
From Last Selection to Low Power Mode
Set the time to move to the [Low Power Mode] after the last operation.
Note • The default for [From Last Selection to Low Power Mode] is [15] minutes. The Low Power
Mode cannot be disabled.
From Last Selection to Sleep Mode
Set the time to move to the [Sleep Mode] after the last operation.
Note • The default for [From Last Selection to Sleep Mode] is [60] minutes. Configure the [From
Last Selection to Sleep Mode] time to be longer than the [From Last Selection to Low Power
Mode] time.
10
Select [Save].
11
Select [Close] repeatedly until the [System Settings] screen is displayed.
12
Select [Exit] to exit the System Administration mode.
Power Saver mode
2
39