Fuji Xerox ApeosPort-II C4300 User Manual page 507

Hide thumbs Also See for ApeosPort-II C4300:
Table of Contents

Advertisement

Category
Error Code
C P F S M O
027-796
O
027-797
033-363
O
033-710
O
033-712
O
033-713
O
033-716
O
033-717
O
033-718
O
033-719
O
033-721
O
033-722
O
033-724
O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
O O [Cause]
The received e-mail was discarded because it had no
attached documents. (The machine is set to print attached
documents only.)
[Remedy] To also print the mail body or header information, change
settings in the Properties screen of CentreWare Internet
Services.
Refer to "E-mail Printing" (P.229).
O O [Cause]
The output destination of the received e-mail is invalid.
[Remedy] Specify a correct output destination, and send the e-mail
again.
[Cause]
An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
[Cause]
The document to be sent by polling was deleted.
[Remedy] Store the document again.
[Cause]
Unable to process due to insufficient memory.
[Remedy] Remove unnecessary data.
[Cause]
An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
[Cause]
The mailbox specified from the sender's machine does not
exist.
[Remedy] Register the mailbox.
Refer to "Mailbox" (P.328).
[Cause]
The mailbox password specified from the sender's
machine is incorrect. Or, the machine password is
incorrect.
[Remedy] Notify the correct password to the sender's machine.
[Cause]
Fax or polling documents do not exist in the mailbox
specified from the sender's machine.
[Remedy] Store fax or polling documents into the mailbox as
necessary.
[Cause]
The document may be deleted by turning off and on the
machine.
[Remedy] Retry sending.
[Cause]
An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
[Cause]
The document is jammed, or the document pages are over
the limit.
[Remedy] Remove the jammed paper or reduce the document
pages, and retry sending.
[Cause]
The reception was interrupted because the image volume
exceeded the upper limit.
[Remedy] Attach a HDD or 256MB Memory to increase the maximum
volume of image data.
Cause and Remedy
Error Code
15
505

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docucentre-ii c2200Apeosport-ii c3300

Table of Contents