Fuji Xerox ApeosPort-II C4300 User Manual page 485

Category
Error Code
C P F S M O
016-751
O
016-752
O
016-753 O
016-755
O
016-756
016-757
016-758
O O O O
016-759 O O
016-760
O
016-761
O
016-762
O
016-764
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
[Cause] 1. During the PDF Bridge processing, one of the following
occurred: a syntax or parameter error occurred; an
undefined command was used; and a PDF file was
damaged.
2. When [Print Processing Mode] for the PDF Direct Print
feature has been set to [PS]: Cause 1 or insufficient
memory.
[Remedy] For Cause 1: Use the print driver to print the document.
For Cause 2: Take one of the following actions:
Use the print driver to print the document.
Expand the PostScript memory.
For information on the memory, refer to "Allocate Memory" (P.303).
[Cause] Unable to process for PDF Bridge due to insufficient
memory space.
[Remedy] Change the [Print Mode] setting from [High Image Quality]
to [Normal], or from [Normal] to [High Speed]. Or, add
memory.
[Cause] The entered password does not agree with that of the PDF
file.
[Remedy] Set the correct password on ContentsBridge.
[Cause] Attempted to process a print protected PDF file.
[Remedy] Cancel the print protection using Adobe Reader, and try to
print again.
O [Cause] No permissions to use the service.
[Remedy] Check with your System Administrator.
O [Cause] The password is incorrect.
[Remedy] Enter the correct password.
[Cause] No permissions to use the service.
[Remedy] Check with your Auditron Administrator.
O [Cause] The number of pages reached the maximum number of
pages for this service.
[Remedy] Check with your Auditron Administrator.
[Cause] An error occurred during PostScript (optional) processing.
[Remedy] Take one of the following actions:
Set [Print Mode] to [Normal].
Expand PostScript memory.
For information about [Print Mode], refer to the print driver's online help.
For information about memory, refer to "Allocate Memory" (P.303).
[Cause] An error occurred during image processing.
[Remedy] Set [Print Mode] to [Normal] and try again. If the problem
persists, set [Page Print Mode] to [On].
[Cause] The specified print language is not installed on the
machine.
[Remedy] In [Specify Print Mode] under [Port Settings], specify
another print language.
O [Cause] Unable to connect to the SMTP server.
[Remedy] Contact the SMTP server administrator.
Cause and Remedy
Error Code
15
483