Fuji Xerox ApeosPort-II C4300 User Manual page 522

15 Problem Solving
Error Code
C P F S M O
116-211
116-212
116-324
116-701 O O
116-702
116-703
116-710
15
116-713
116-714
116-720
116-725
116-740
116-747
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
520
Category
O [Cause]
[Remedy] Connect the cable correctly, and turn the machine off and
O [Cause]
[Remedy] Turn off the machine once, then hold down both the
[Cause]
[Remedy] Add on memory, or attach a HDD if it is unattached.
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Either check the print data, or click [Spool Settings] on the
O [Cause]
[Remedy] Increase the size assigned to HP-GL/2 auto-layout
O [Cause]
[Remedy] Remove unnecessary data from the hard disk to increase
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Stop unnecessary ports or remove unnecessary data from
O [Cause]
[Remedy] Execute the job again.
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Decrease the paper margin value, and try again.
Cause and Remedy
The connecting cable is not correctly connected to the
media reader.
on. If the problem persists, contact our Customer Support
Center.
An error occurred on the machine.
<Start> and <Stop> buttons simultaneously for 6 seconds
when turning the machine back on. This will delete the
print data which caused the error.
Unable to use the 2-sided printing feature due to
insufficient memory.
Printing was performed using a substitute font.
An error occurred during PostScript (optional) processing.
[Details] tab in the print driver to set bi-directional
communication to off.
A probable cause is that the correct document size could
not be judged as the receive data exceeded the HP-GL/2
spool size.
memory.
Job was divided and printed due to insufficient disk space.
free disk space.
An HP-GL/2 command error occurred.
An error occurred during print processing due to
insufficient memory.
the hard disk, to increase free disk space.
Unable to write the image log because the image log save
space is insufficient on the machine.
If this error persists, take one of the following actions:
Delete unnecessary image logs.
Change the [Assurance Level] setting for image logs to
[Low]. Note that selecting [Low] will not secure the
contents of created image logs.
Numerical value operation error occurred as a value
exceeding the value limit of the printer was used in the
print data.
The paper margin value is too large for the HP-GL/2
effective coordinate area.