Using The Power Switch Cover Security Feature - Compaq ProLiant 800 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6. Connect the drive power and signal cables.
Figure 3-23.
7. Remove the blank drive bezel from the inside of the front bezel, if
necessary.
8. Replace the front bezel and side access panel.
9. Reconfigure the server. Refer to Chapter 4, "Using the System
Configuration Utility," for more information.
Using the Power Switch Cover
Security Feature
The server is shipped from the factory with the power switch cover security
feature in the locked position. This protects the server from accidentally being
shutdown due to incidental contact with the power switch cover. To turn the
server ON or OFF, you must use a thin object to depress the center circle of
the power switch cover. An eraser end of a pencil works well.
Connecting the drive cables
Writer: Project: Installing Hardware Options Comments:
File Name: E-ch3.doc Last Saved On: 4/23/97 11:22 AM
Compaq ProLiant 800 Server Reference Guide
3-29