2-22 Compaq ProLiant DL760 Servers Maintenance and Service Guide
Power On/Standby Switch Assembly
To remove the Power On/Standby switch:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the media module bezel. See "Media Module Bezel" earlier in this chapter.
3. Remove the media module. See "Removing the Media Module" earlier in this chapter.
4. Unplug the IMD cable from the media backplane board. See "Media Module Cable
Routing Diagram" earlier in this chapter.
5. Remove the IMD. See "Integrated Management Display" earlier in this chapter.
6. Disconnect the Power On/Standby switch connector from the media backplane board
See "Media Module Cable Routing Diagram" earlier in this chapter.
7. Loosen the thumbscrew that secures the power switch plate to the media backplane
board
Figure 2-16. Unplugging the power switch cable and loosening the thumbscrew
.
2
.
1