Step 2: Connect Power; Step 3: Configure The Cn3000 - Colubris Networks CN3000 Administrator's Manual

Chapter 3 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -Installation - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 3

Step 2: Connect power

Connect the power supply to the CN3000, then use the power cord to connect the
power supply to a wall outlet.
The CN3000 automatically starts up when you connect the power (there is no on/off
switch) and becomes fully operational when the power light stops flashing. For more
information on the front panel lights, refer to

Step 3: Configure the CN3000

You are now ready to configure the CN3000 by starting the management tool. See
"Management tool" on page 26
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 66 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
bottom
for details.
"Status lights" on page 62.