Chapter 11 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -Configuration parameters - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 11
PPTP client
Open the Security > PPTP client page.
PPTP server address
Connection
Specify the domain name or IP address of the PPTP server the CN3000 will connect to.
Domain name(s)
Specify the domain name(s) of the PPTP server. Put a space between each name as a
separator. The CN3000 routes all traffic addressed to this domain through the PPTP
connection.
Auto-connect at start-up
Enable this option if you want the CN3000 to automatically establish the PPTP
connection when it restarts.
Auto-route discovery
Enable this option if you want the CN3000 to automatically discover and add routes to IP
addresses on the other side of the PPTP tunnel. The addresses must be part of the
specified domain. Routes are added only when an attempt is made to access the
addresses.
LCP echo
Certain VPN servers may terminate your connection if it is idle. If you enable this option,
the CN3000 will send a packet from time to time to keep the connection alive.
Account
Username
Specify the username the CN3000 will use to log on to the PPTP server. If you are
logging on to a Windows NT domain, specify: domain_name\username
Password / Confirm password
Specify the password the CN3000 will use to log on to the PPTP server.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 256 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -