Step 3: Configure Steel-Belted Radius On Server 1; Modify The Default Configuration Files; Start And Connect To The Server - Colubris Networks CN3000 Administrator's Manual

Chapter 14 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Sample setup - Backend software - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 14

Step 3: Configure Steel-Belted Radius on Server 1

Modify the The Backend archive file contains modified configuration settings for the Steel-Belted
Radius server to make it work in this example.
default
1. Open a command-line session.
configuration
2. Execute the command: net stop "Steel-Belted Radius"
files
3. Copy the following files from c:\colubris\radius\ to c:\radius\service\.
4. If you are using an older version of Steel-Belted Radius, you should also copy the
Start and
1. Open a command-line session.
2. Execute the command: net start "Steel-Belted Radius"
connect to the
3. On the Start menu, click Steel-Belted Radius, then click Steel-Belted Radius
server
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 305 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
This stops the Steel-Belted Radius server. (It was automatically started after
installation.)
• Sqlacct.acc
• Sqlacct2.acc
• Sqlauth.aut
If you are prompted to replace the files, do so.
files in c:\colubris\radius\older_version\ to c:\radius\service\.
Administrator. The following window opens.