Starting The Management Tool; Remote Management - Colubris Networks CN3000 Administrator's Manual

Chapter 2 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - How it works - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 2

Remote management

• A remote computer connected to the CN3000 via the Internet.
• A computer on the remote network the CN3000 has established a VPN connection to.
Starting the 1. Start your Web browser.
2. In the address box, specify:
management
tool
3. Press Enter. You will be prompted to accept a Colubris Networks security certificate.
4. After you accept the Colubris Networks certificate, the management tool login page
Access to the management tool is protected by a username and password. The factory
default setting for both is admin. It is recommended that you change both using the
Management > Management tool page.
If you forget the administrator password
The only way to gain access to the management tool if you forget the administrator
password is to reset the CN3000 to factory default settings. See
defaults" on page
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 27 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
( Make sure that you specify HTTPS and not HTTP. )
Do so to continue. (To eliminate this warning message you can install your own
certificate as described in
Note: To safeguard the security of the CN3000, access to the management tool must occur
via a secure connection. Before this connection can be established, you must accept a Colubris
Networks security certificate. The procedure for accepting the certificate varies depending on
the browser you are using.
opens. By default, the username and password are both set to admin.
Administrator password
63.
HTTPS://192.168.1.1
Chapter 10.)
.
"Resetting to factory