Equipment Setup; Topology; About The Components - Colubris Networks CN3000 Administrator's Manual

Chapter 16 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Sample setup - Microsoft RADIUS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 16

Equipment setup

This section illustrates the hardware setup that was used to create the sample
configuration described in this chapter. If you duplicate this setup, you will not have to
change any of the IP addresses supplied in the example.

Topology

The goal of this setup is to simulate a working environment with the least amount of
equipment. To this end, the 'public network' is considered to be any device connected to
the LAN or wireless port on the CN3000. The 'protected network resources' are
connected to the Internet port on the CN3000. In this example, both Server 1 and
Server 2 are on the protected network. Server 1 hosts the IAS server. Server 2 is used
to simulate an external web server.
Or you can use this setup. Both are functionally identical.
See
About the
Server 1
components
Server 1 is the computer that you install Windows 2000 server and IAS on.
Server 2
Server 2 is required to test the setup once it is complete. You should install a web server
on this computer. The client station will attempt to access this web server via the
CN3000.
Client station
The client station is required to test the setup once it is complete. The DHCP server on
the CN3000 will assign an address to this computer.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 357 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Client station
LAN port
192.168.1.1
192.168.1.2
x-over cable
CN3000
Client station
192.168.1.2
"Wiring details" on page 288
CN3000
Server 1
Internet port
192.168.2.1
hub
Server 1
192.168.2.99
Internet port
192.168.2.1
hub
for information on how to build a x-over cable.
Server 2
192.168.2.99 192.168.2.100
Server 2
192.168.2.100