Chapter 3 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -Installation - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 3
Anatomy
Reset button
Status lights
Status lights
The status lights on the front panel provide operational information.
Startup behavior
When power is applied to the CN3000, the power light will start flashing. When the
power light stops flashing, initialization is complete and the CN3000 is fully operational.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 62 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
on
The CN3000 is fully operational.
flashing
The CN3000 is starting. up.
off
Power is off.
on
Internet port is fully operational. An IP address is assigned to it by the network.
flashing
Internet port is connected to a broadband link or WAN, but an IP address is not yet assigned.
off
Internet port is not connected.
flashing
Internet port is receiving data.
on
LAN port is connected and is fully operational.
off
LAN port is not connected to a network, or the device it is connected to is off.
flashing
LAN port is receiving data.
on
LAN port is operating at 100 Mbps.
off
LAN port is operating at 10 Mbps.
on
Wireless port is fully operational.
off
Wireless port is not ready (wireless card is not installed).
flashing
Wireless port is receiving data.
LAN port
Internet port
Used to connect to
Used to connect to a
a wired LAN.
broadband modem
or a network.