Step 5: Install And Configure The Cn3000; Start Apache; Assign A Static Address - Colubris Networks CN3000 Administrator's Manual

Chapter 14 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Sample setup - Backend software - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 14

Step 5: Install and configure the CN3000

Follow the directions in
section.

Start Apache

Make sure that the Apache web server is running. If not, then:
1. Launch a new command-line session.
2. Run c:\opensa\apache\apache.exe –D SSL. This starts Apache in secure mode.
Assign a static Perform the following steps using the CN3000 Management tool.
1. On the Network menu, click Ports.
address
2. Click Internet port in the table.
3. Select Static and then click Configure.
4. Make the following settings:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 313 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Chapter
• IP address: Assign an address. For this example, use the address: 192.168.2.1
• Address mask: Assign an appropriate mask. For this example, use the mask:
255.255.255.0.
• Default gateway: Leave blank. In a real setup this would be set to the address of
the router providing access to the Internet.
3: Installation then continue with the instructions in this