Reset Button - Colubris Networks CN3000 Administrator's Manual

Chapter 3 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -Installation - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 3
Brown-out warning
For protection, the CN3000 automatically suspends operation if it detects a brown-out
on the power line. To indicate this condition, the status lights will display as follows:
• the top three lights will be off
• the bottom five lights will be on
To resume normal operations, disconnect and reconnect power.

Reset button

The reset button is located on the side of the CN3000. Use the end of a paper clip or
another pointy object to press the button.
Restarting
Press and release the button quickly to restart the CN3000. This is equivalent to
disconnecting and reconnecting the power. The CN3000 will restart immediately.
Resetting to factory defaults
To reset the CN3000 to its factory default settings, do the following:
1. Press and hold the reset button. All the lights on the CN3000 front panel will light up.
2. When the lights begin to flash (after about five seconds), immediately release the
3. The CN3000 will restart with factory default settings. When the power light stops
Important: Resetting the CN3000 deletes all your configuration settings, resets the
Administrator username and password to 'admin' , and sets the Wireless port and LAN
port IP addresses to 192.168.1.1.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 63 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
button.
flashing, the CN3000 is fully operational.