Sensor (Booklet Rear Tamper Hp) Removal; Sensor (Booklet Unit Interlock) Removal - Lexmark X95 series Service Manual

Sensor (booklet rear tamper HP) removal

Remove the booklet unit assembly. See
1.
2. Remove the booklet unit assembly left cover. See
page 4-334.
Disconnect the connector from the booklet left tamper sensor.
3.
Remove the screw securing the sensor (booklet rear tamper HP) bracket from the booklet unit assembly.
4.
5. Remove sensor (booklet rear tamper HP) (A).

Sensor (booklet unit interlock) removal

Open the finisher front door assembly.
1.
2. Pull the booklet unit assembly out of the finisher.
Remove rear lower cover. See
3.
Disconnect the connector from the sensor (booklet unit interlock).
4.
"Booklet unit chassis removal" on page
A
Connector
"Upper media bin front cover removal" on page
"Booklet unit assembly left cover removal" on
Left
Repair information
7558-xxx
Previous
4-335.
Go Back
4-423.
4-387
Next