Upper Media Exit Roll Assembly Removal - Lexmark W850n Manual

4024-110

Upper media exit roll assembly removal

1.
Open the finisher front door assembly.
2.
Remove the rear upper cover. See
3.
Remove the top cover. See
4.
Remove the drive motor (exit). See
page 4-113.
5.
Disconnect the connector from the sensor (upper media exit) (A).
6.
Release the harness from the clamps.
7.
Remove the two front and two rear screws securing the upper exit guide assembly (B).
8.
Remove the upper exit guide assembly.
9.
Remove the two front screws and the two rear screws securing the bracket (C) to the finisher.
Front
4-106
Finisher Service Manual
"Rear upper cover removal" on page
"Top cover removal" on page
"Drive motor (exit) assembly and belt (exit) removal" on
4-24.
4-19.
A
Connector
Left
Rear