Paper Exit Sensor Removal - Lexmark Pro910 Series Service Manual

Paper exit sensor removal

1.
Remove the following:
a.
Left side cover.
b.
Right side cover. See
c.
System board shield. See
d.
Scanner unit. See
e.
Midframe cover and control panel. See
page 4-38.
Note: Do not detach the control panel from the midframe cover.
2.
Disconnect the cable (A), and remove the screws (B) to detach the paper exit sensor.
Installation note:
Make sure that the cable (C) is secure and does not block the paper exit sensor flag.
See"Left side cover removal" on page
"Right side cover removal" on page
"System board shield removal" on page
"Scanner unit removal" on page
"Midframe cover and control panel removal" on
Lexmark Pro910 Series
4-23.
4-25.
4-28.
4-30.
Repair information
Previous
Next
Go Back
Disassembly
Flowchart
4-45