Sensor (Narrow Media) Removal - Lexmark XM3250 Service Manual

Sensor (narrow media) removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the scanner rear cover. See
4
Remove the rear cover. See
5
Position the printer on its left side.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
6
Remove the power supply. See
7
Remove the duplex assembly. See
8
Remove the screws (A) to access the sensor under the motor bracket.
9
Remove the screw (B), and then release the sensor.
10
Disconnect the sensor cable from the controller board.
11
Remove the sensor.
"Left cover removal" on page
"Right cover removal" on page
"Scanner rear cover removal" on page
"Rear door and cover removal" on page
"Power supply removal" on page
"Duplex removal" on page
Parts removal
293
226.
237.
294.
295.
273.
275.
7018