Wipe All Settings; Duplex Gloss; Font Sharpening; Require Standby - Lexmark X746de Service Manual

Wipe All Settings

The purpose of this setting is to make any sensitive information that may exist on the device's volatile or non-
volatile storage completely indecipherable.
After selecting this setting, the operator panel displays the following message:
This operation will clear all settings, solutions, and jobs on this device. The device will
reboot during this process. Continue?
To cancel the NAND wipe operation and return to the main Configuration Menu, select No. To execute the
NAND wipe operation, select Yes.
After selecting Yes, the device initiates a non-critical NVRAM reset, and the operator panel displays the
message Resetting the device, and then the device reboots.
The progress bar area of the Lexmark logo screen that appears during boot up displays the following message
until the wiping process is finished:
Wiping disk...Pass [x] of [y]. [Z]% done.

Duplex Gloss

If you need higher quality duplex copies, selecting Duplex Gloss give you a higher quality output. It does this by
limiting the number of pages fed at one time. In normal duplex, two sheets are fed simultaneously and one is
printed on page two and the other is printed as page four, then the pages are re-fed and pages one and three
are printed on the other side. With Duplex Gloss turned on, only one page is fed, printed, re-fed and the reverse
is printed. The quality increases, but the time it takes to complete the job is increased.
To turn on Duplex Gloss:
1. Touch Duplex Gloss from the Configuration Menu.
Touch the
2.
Touch Submit.
3.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Font Sharpening

Lets a user set a text point-size value below the setting of the high frequency screens used when printing font
data. This menu item only affects the PostScript, PCL, XL, and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high frequency screens. To increase value by 1, touch the right arrow; to decrease the
value by 1, touch the left arrow.
To set Font Sharpening:
1. Touch Duplex Gloss from the Configuration Menu.
Touch the
2.
Touch Submit.
3.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Require Standby

When set to Off, the Standby Mode setting in General Settings Menu displays Disabled. The default is On.
or arrow to toggle between Off and On.
or arrow to change the value from 1 to 150.
7526
Previous
Go Back
Diagnostic aids
3-43
Next