Sensor (Stapler Carriage Hp) Late Jam - Lexmark X95x Series Service Manual

7558-xxx

381.05 Sensor (stapler carriage HP) late jam

Step Action and questions
Check the stapler by moving it
1
manually.
Does the above component
slide back and forth properly?
Check the sensor (stapler
2
carriage HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (stapler
carriage HP).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (stapler
3
carriage shift HP) for proper
connection.
Is the above component
properly connected?
Check the stapler carriage motor
4
assembly for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Stapler carriage
motor (forward).
5. Touch Stapler carriage
motor (rearward).
Does the above component
operate properly?
Check the stapler transport motor
5
for proper connection.
Is the above component
properly connected?
Perform a POR.
6
Does the error continue when
the power is turned off/on?
Service Manual
2-180
Yes
Go to step 2.
Go to step 4.
Replace the sensor (stapler
carriage HP). Go to
"Sensor
(stapler carriage HP) removal"
on page 4-407.
Go to step 6.
Replace the stapler transport
motor.
Replace the finisher controller
PCBA. Go to
"Finisher PCBA
removal" on page 4-356.
No
Remove obstructions.
Go to step 3.
Replace the connection.
Go to step 5.
Replace the connection
Problem resolved
Previous
Next
Go Back