Replacing The Intermediate Transfer Roller - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 7.0 Jun. 2008
2.1.2

Replacing the intermediate transfer roller

A. Periodically replaced parts/cycle
• Intermediate transfer roller: Every 100,000 prints
NOTE
• When replacing the intermediate transfer rollers, be sure to replace all 2 pairs of
rollers (4 rollers in all).
B. Replacing procedure
1. Open the front door.
[4]
[3]
[1]
[2]
[1]
A07RF2C504DA
[2]
A07RF2C501DA
2. Periodical check
2. Remove two screws [1], the bearing
[2] and remove the intermediate
transfer roller assy [3].
NOTE
• When installing the intermediate
transfer roller, be sure to insert the
pin [4] at the rear of the shaft of the
intermediate transfer roller into the
groove.
3. Insert a driver into the groove [1] of
the intermediate transfer roller and
remove the intermediate transfer
roller [2] by prizing it open.
7