Mini-Usb Port Specifications For An Ex2200 Switch; Table 10: Mini-Usb Type-B Console Port Pinout Information For Ex2200-C; Table - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
Related
Documentation

Mini-USB Port Specifications for an EX2200 Switch

Table 10: Mini-USB Type-B Console Port Pinout Information for EX2200-C Switches
Pin Signal
1 VCC
2 D-
3 D+
X N/C
4 GND
Related
Documentation
22
See EX2200 Switches Hardware Overview on page 3
See Rear Panel of an EX3200 Switch for port location.
See Rear Panel of an EX3300 Switch for port location.
See Rear Panel of an EX4200 Switch for port location.
See Front Panel of an EX4500 Switch for port location.
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch for port
location.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for port
location.
See Routing Engine (RE) Module in an EX8216 Switch for port location.
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
The EX2200-C switch, the compact, fanless model, has two management console ports:
an RJ-45 port, and a Mini-USB Type-B port.
By default, the RJ-45 port is set as the active console port. It can display all the early boot
and low-level message output and you can access the switch through this port in the
debugger prompt. The Mini-USB Type-B port is the passive console port. You can change
the status of the port to active or passive using the
See Configuring the Console Port Type (CLI Procedure).).
The Mini-USB Type-B console port uses a Mini-B plug (5-pin) connector to connect to
a console management device. The default baud rate for the console port is 9600 baud.
Table 10 on page 22 provides the pinout information of the Mini-USB Type-B console
port.
Description
+5 VDC
Data -
Data +
May be N/C, GND or used as an attached device presence indicator
Ground
See EX2200 Switches Hardware Overview on page 3
Configuring the Console Port Type (CLI Procedure)
for port location.
configuration statement.
port-type
for port location.
Copyright © 2011, Juniper Networks, Inc.