Juniper EX2200 Series Hardware Manual page 160

Complete Hardware Guide for EX2200 Ethernet Switches
Related
Documentation
140
To disconnect a fiber-optic cable from an optical transceiver installed in the switch:
Disable the port in which the transceiver is installed by issuing the command:
1.
[edit interfaces]
user@switch# set interface-name disable
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Carefully unplug the fiber-optic cable connector from the transceiver.
2.
Cover the transceiver with a rubber safety cap.
3.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
Cover the fiber-optic cable connector with the rubber safety cap.
4.
Connecting a Fiber-Optic Cable to an EX Series Switch on page 121
Removing a Transceiver from an EX Series Switch on page 137
Maintaining Fiber-Optic Cables in EX Series Switches on page 143
Optical Interface Support in EX2200 Switches on page 25
Optical Interface Support in EX3200 Switches
Optical Interface Support in EX3300 Switches
Optical Interface Support in EX4200 Switches
Optical Interface Support in EX4500 Switches
Optical Interface Support in EX6200 Switches
Optical Interface Support in EX8200 Switches
Copyright © 2011, Juniper Networks, Inc.