Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper EX2200 Series Hardware Manual

Related
Documentation

Connecting and Configuring an EX Series Switch (CLI Procedure)

Copyright © 2011, Juniper Networks, Inc.
}
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Configuration Files Terms
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 129
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 131
Understanding Configuration Files for EX Series Switches
EX2200 Switches Hardware Overview on page 3
There are two ways to connect and configure an EX Series switch: one method is through
the console using the command-line interface (CLI) and the other is using the J-Web
interface.
NOTE: EX2200-24T-DC switches, EX2200-C switches, EX3300 switches,
and EX6200 switches do not support switch connection and configuration
through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the EX Series Switch.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud rate—9600
Flow control—None
Data—8
Parity—None
Chapter 11: Performing Initial Configuration
ezsetup script, the switch must have the factory default
, revert to the factory default configuration.
ezsetup
129