Configuring The Modem; Table 27: Port Settings - Juniper EX2200 Series Hardware Manual

Configuring the Modem

Table 27: Port Settings

Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
Copyright © 2011, Juniper Networks, Inc.
Press Enter when you see the following message:
4.
Switch baud rate to 115200 bps and press Enter.
The prompt reappears.
loader>
Save the new serial console speed:
5.
loader> save
Press Enter. The serial console speed is now set to 115200 baud.
Boot the software:
6.
loader> boot
The boot process proceeds as normal and ends with a login prompt.
Before you connect the modem, you must configure the modem with the required port
settings.
NOTE: The following procedure uses Hayes-compatible-modem commands
to configure the modem. If your modem is not Hayes-compatible, see the
documentation for your modem for the equivalent modem commands.
To configure the modem:
Connect the modem to the desktop or notebook computer.
1.
Power on the modem.
2.
From the computer, start your asynchronous terminal emulation application (such
3.
as Microsoft Windows HyperTerminal) and select the COM port to which the modem
is connected (for example, COM1).
Configure the port settings shown in
4.
In the HyperTerminal window, type
5.
Chapter 10: Connecting the Switch
Table 27 on page 119.
Value
115200
8
None
1
None
. Press Enter.
at
119