Figure 24: Measurements For Installing Mounting Screws For Ex2200-C; Switch - Juniper EX2200 Series Hardware Manual

Copyright © 2011, Juniper Networks, Inc.

Figure 24: Measurements for Installing Mounting Screws for EX2200-C

Switch

.536 "
(1.36 cm)
A
3.98 "
(10.13 cm)
P
4.37"
(11.0 cm)
Drill hole A and install a mounting screw.
a.
Drill hole B 9.52 in. (22.1 cm) on a level line from hole A and install a mounting
b.
screw.
Mark a point P 3.98 in. (10.13 cm) on a plumb line down from hole A.
c.
From point P 4.37 in. (11.0 cm) on a level line drill hole C and install a mounting
d.
screw.
Tighten the screws only part way in, leaving about 1/4 in. (6 mm) distance between
2.
the head of the screw and the desk.
Place the switch on the mounting screws, and slide it forward or backward until it
3.
locks in place. See Figure 25 on page
9.52"
(22.1 cm)
C
80.
Chapter 8: Installing the Switch
B
3.98 "
(10.13 cm)
79