Management Port Connector Pinout Information For Acx500 Routers - Juniper ACX500 Hardware Manual

Table 28: Connector Pinout for the Console Port
Pin Signal
1 RTS
2 NC
3 TXD
4 Ground
5 Ground
6 RXD
7 NC
8 CTS

Management Port Connector Pinout Information for ACX500 Routers

The management port—labeled MGMT—on an ACX Series router uses an RJ-45 connector to connect to
a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000BASE-T connection. Two LEDs
indicate link and /activity on the port and the administrative status of the port.
Table 29 on page 105 provides the pinout information for the RJ-45 connector for the management
port.
Description CPU
Request to Send Routing Engine
No Connect –
Transmit Data Routing Engine
Signal Ground –
Signal Ground –
Receive Data Routing Engine
No Connect –
Clear to Send Routing Engine
Direction
Out
–
Out
–
–
In
–
In
104