Ex2200 Switch Models; Figure 5: Rear Panel Of An Ex2200 Switch With An Ac Power Supply; Figure 6: Rear Panel Of An Ex2200-C-12P Switch With Heatsink - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches
Related
Documentation

EX2200 Switch Models

8

Figure 5: Rear Panel of an EX2200 Switch With an AC Power Supply

Protective
Management
Ethernet port earthing terminal
USB Console
port
port
The rear panel of an EX2200-C switch consists of the following components:
Protective earthing terminal
ESD point
Serial number ID label
AC power cord inlet
Heatsink-only in PoE+ models
Figure 6 on page 8 shows the rear panel of an EX2200-C-12P switch with heatsink.
EX2200-C switches being fanless models have no exhaust openings. The switch has
vents on the top and on both the sides of the chassis. The PoE+ models have heatsink
installed in the rear panel to dissipate the heat, while non-PoE models have no heatsink.

Figure 6: Rear Panel of an EX2200-C-12P Switch with Heatsink

Heatsink
EX2200 Switch Models on page 8
Site Preparation Checklist for EX2200 Switches on page 51
The EX2200 switch is available with 12, 24, or 48 built-in network ports with full Power
over Ethernet (PoE) capability (all 12, 24, or 48 built-in network ports support PoE) or no
PoE capability. EX2200 switches with DC power supply do not provide PoE.
page 9 lists the EX2200 switch models.
ESD
point
Air exhaust Air exhaust without fan
with fan (closed on non-PoE models)
Air intake with fan for power supply
(fan on PoE models only)
EX2200-24-4G REV: X1
750-026464 REV: X3 Mfg. Date
20090227
MAC: 00:23:9C:oE:19:00
MADE IN CHINA
Serial number AC power
ID label cord inlet
Table 1 on
Copyright © 2011, Juniper Networks, Inc.