Juniper EX2200 Series Hardware Manual page 158

Complete Hardware Guide for EX2200 Ethernet Switches
138
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Remove the cable connected to the transceiver (see
3.
Cable from an EX Series Switch" on page
each fiber-optic cable connector with a rubber safety cap immediately after
disconnecting the fiber-optic cables.
Using your fingers, pull the ejector lever on the transceiver to unlock the transceiver.
4.
CAUTION: Before removing the transceiver, make sure you open the ejector
lever completely until you hear it click. This prevents damage to the
transceiver.
Using the needlenose pliers, pull the ejector lever out from the transceiver.
5.
Grasp the transceiver ejector lever and gently slide the transceiver approximately
6.
0.5 in. (1.3 cm) straight out of the port.
CAUTION: To avoid electrostatic discharge (ESD) damage to the
transceiver, do not touch the connector pins at the end of the transceiver.
Using your fingers, grasp the body of the transceiver and pull it straight out of the port.
7.
Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat,
8.
stable surface.
Place the dust cover over the empty port.
9.
"Disconnecting a Fiber-Optic
139). Cover the transceiver and the end of
Copyright © 2011, Juniper Networks, Inc.