Juniper EX2200 Series Hardware Manual page 154

Complete Hardware Guide for EX2200 Ethernet Switches
Related
Documentation
134
Click Next.
8.
On the Manage Access page, you may select options to enable Telnet, SSH, and SNMP
9.
services. For SNMP, you can configure the read community, location, and contact.
Click Next. The Summary screen displays the configured settings.
10.
Click Finish. The configuration is committed as the active switch configuration.
11.
NOTE: After the configuration is committed, the connectivity between
the PC and the switch might be lost. To renew the connection, release and
renew the IP address by executing the appropriate commands on the
management PC or by removing and reinserting the Ethernet cable.
(For EX4500 switches only) In the CLI, enter the
12.
operational mode command to set the PIC mode to intraconnect.
You can now log in using the CLI or the J-Web interface to continue configuring the switch.
If you use the J-Web interface to continue configuring the switch, the Web session is
redirected to the new management IP address. If the connection cannot be made, the
J-Web interface displays instructions for starting a J-Web session.
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 129
Installing and Connecting an EX2200 Switch on page 71
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX4200 Switch
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
request chassis pic-mode intraconnect
Copyright © 2011, Juniper Networks, Inc.