Mounting an EX2200-C Switch on a Wall
Copyright © 2011, Juniper Networks, Inc.
Figure 36: Mounting the Switch on a Wall
Hang attached brackets
on wall-mounted screws.
You can mount an EX2200-C switch, the compact, fanless model, on a wall by using the
flexible mounting slots on the bottom of the chassis to fix to the screws on the wall.
WARNING:
When mounting an EX2200-C switch chassis in a vertical position,
orient the front panel of the chassis downward to ensure proper airflow and
meet safety requirements in the event of a fire.
NOTE:
Do not block the vents on the top of the EX2200-C switches. Doing
this can lead to overheating of the switch chassis.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX2200 Switches" on page
Read
"General Safety Guidelines and Warnings" on page
to
"Chassis Lifting Guidelines for EX2200 Switches" on page
Ensure that you have the following parts and tools available:
3 wall mounting screws (M4 x 30mm or 8-32 x 1.25 in. Phillips pan-head machine
screws—not provided)
Phillips (+) screwdriver, number 2
1 cable guard and 3 number-8 Phillips truss-head screws (optional and separately
orderable) to secure the cable guard to the switch
1 standard cable lock (optional and separately orderable) to secure the switch from
theft by connecting the cable to a security slot on the switch
Baffle for PoE Models
Rear
(EX2200-24P and EX2200-48P)
panel
Front
panel
51.
Chapter 8: Installing the Switch
"Site Preparation Checklist
155, with particular attention
166.
91