External Clocking Ports Specifications On Acx500 Routers; Management Port Connector Pinout Information For Acx500 Routers; Port Cable And Pinout Specifications; Table 29: Management Port Connector Pinout Information - Juniper ACX500 Hardware Manual

External Clocking Ports Specifications on ACX500 Routers

Related
Documentation

Management Port Connector Pinout Information for ACX500 Routers

Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
The external clocking port on the ACX500 router contains four SMB connectors that
support 1 pulse-per-second (PPS) signal. These signals are internally isolated and have
surge protection. Use a Molex 50-ohm SMB connector or equivalent (not provided) to
connect to the external clocking ports.
ACX500 Universal Access Router Overview on page 3
Front Panel of an ACX500 Indoor Router on page 33
LEDs on ACX500 Routers on page 41
Clocking Ports on ACX500 Routers on page 45
The management port—labeled
to connect to a management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000BASE-T
connection. Two LEDs indicate link and /activity on the port and the administrative status
of the port.
Table 29 on page 77 provides the pinout information for the RJ-45 connector for the
management port.

Table 29: Management Port Connector Pinout Information

Pin Description
1 TRD[0]+
2 TRD[0]-
3 TRD[1]+
4 TRD[2]+
5 TRD[2]-
6 Pin6 TRD[1]-
7 TRD[3]+
8 TRD[3]-
ACX500 Universal Access Router Overview on page 3
Front Panel of an ACX500 Indoor Router on page 33
Chapter 7: Port Cable and Pinout Specifications
MGMT —on an ACX Series router uses an RJ-45 connector
Direction
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
In/Out
77