Mounting An Ex2200 Switch On Or Under A Desk Using Screws - Juniper EX2200 Series Hardware Manual

Complete Hardware Guide for EX2200 Ethernet Switches

Mounting an EX2200 Switch On or Under a Desk Using Screws

78
This topic applies only to the EX2200-C switch, the compact, fanless model.
You can mount an EX2200-C switch on or under a desk or other level surface by using
the flexible mounting slots on the bottom of the chassis to secure the switch.
Before mounting the switch on or under a desk or other lever surface:
Verify that the site meets the requirements described in
for EX2200 Switches" on page
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX2200 Switches" on page
Remove the switch from the shipping carton (see
page 72).
NOTE: Do not block the vents on the top of the EX2200-C switches. Doing
this can lead to overheating of the switch chassis.
Ensure that you have the following parts and tools available:
3 desk mounting screws (M4 x 30mm or 8-32 x 1.25 in. Phillips pan-head machine
screws—not provided)
Phillips (+) screwdriver, number 2.
1 cable guard and 3 number-8 Phillips truss-head screws (optional and separately
orderable) to secure the cable guard to the switch
1 standard cable lock (optional and separately orderable) to secure the switch from
theft by connecting the cable to the security slots on the switch
To mount the switch on or under a desk or other level surface:
Drill three holes A, B, and C on or under the desk as shown in
1.
"Site Preparation Checklist
51.
155, with particular attention
"Unpacking an EX2200 Switch" on
Copyright © 2011, Juniper Networks, Inc.
166.
Figure 24 on page 79.